 |
|
Does anyone know where I might be able to find a diagram that outlines what each connector is for on the harness that plugs into the DME? I am trying to track down the coil ground so I can do a continuity test. I keep frying coils and am still not getting any ignition. There is no outline in the Bently, and I cannot find it in the manual I downloaded either.
Thanks in advance
Greg Moberg
I thougth that the bentley’s had a pretty good pin detail in the fuel injection section. make sure you look at the right one. It also goes through some tests of the diff sensors.
Michael
Frying coils with no spark is going to be a short in the wiring from the coil to the DME, or a bad DME. Unplug the DME (with battery disconnected), disconnect the wire from the coil, and see if you have an open circuit w/respect to ground. If that checks out the DME is the cause.