Battery cable lugs for cut off switch

#1

Does anyone know where I can get some lugs for the fat ass battery cable to wire it to my opm kill switch? I have been looking everywhere but cant seem to find ones that will take the 1/2 inch or so cable. Thanks!

#2

I picked up some at an industrial electrical supply company (gexpro). They were around $3 each.

#3

I picked up some 2 gauge lugs at Autozone yesterday.

#4

NAPA has a good selection of them.

#5

If your putting one on the existing battery cable in the car (to increase the ring terminal size), you’ll have to take a torch to the old one to heat it up and get the joint to unsolder. Then to put the new one on you may have to heat it again to the the wires soft enough to fit into you new terminal. The stock cable strands are very stiff when filled with solder.

#6

Welding supply shops usually have a large selection of lugs.

#7

Went down to the local welding supply store and got a couple thanks for the info!

#8

thanks for suggestion.

Ready to assemble cabinets